Slider
Introduction
Pinned Items
Recent Activities
  • Another question. What’s the best way to reapply the Gizmo Dorks 1mm PEI. I got some bubbles in it, causing a bubble in the leveling.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Quick question. Are the Prusa Slicer profiles compatible with Super Slicer?
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • David Carter is now following Earl Miller
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • David Carter is now following Ed Paulsen
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • David Carter liked the page, Artillery / Evnovo 3D Printers
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • David Carter reacted to an article, 3D Nexus Affiliate Disclosure
     
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • David Carter just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.

3D-Nexus is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com at no additional cost to you.