Slider
Introduction
Pinned Items
Recent Activities
  • I'm stupid maybe but I cannot get the profile imported in cura 4.2.1. I'm using prusaslicer because I got that working better than Cura but wanted to give it another try using the published profiles. But somehow I don't get it imported. I tried...
    I'm stupid maybe but I cannot get the profile imported in cura 4.2.1. I'm using prusaslicer because I got that working better than Cura but wanted to give it another try using the published profiles. But somehow I don't get it imported. I tried the file from the files section on facebook and the one on this site. Maybe I'm doing something wrong here ?
    More
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Edwin Ringers just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.

Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.