3D Nexus Community and Development Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Make sure you use your real E-mail address since registration cannot be completed without a valid one and is manually checked.

Beginner 3DN MBL not working

cohenziv7

New member
Registered User
Hey, it seems like the MBL is not saved to memory, is there a way to check I flashed the firmware correctly ? Cause I think I maybe didnt flash the firmware correctly to the board, though I thought it wont work at all if I did that, but it does do all the process of MBL, but the leveling just sucks (tried literally over 40 times)
 

3DN Fen

Grand Poo-bah
Staff member
Administrator
Hey, it seems like the MBL is not saved to memory, is there a way to check I flashed the firmware correctly ? Cause I think I maybe didnt flash the firmware correctly to the board, though I thought it wont work at all if I did that, but it does do all the process of MBL, but the leveling just sucks (tried literally over 40 times)
G29 S0 will produce a mesh report.

> G29 S0
Num X,Y: 3,3
Z offset: 0
Measured points:
0 1 2
0 +0.011 -0.020 -0.026
1 +0.017 +0.002 -0.019
2 +0.022 -0.030 -0.013 (example)

Further reading- Bed Leveling (Manual)
 
Top