Slider
Introduction
Pinned Items
Recent Activities
  • Evening all, hope everyone is staying safe, not trotting off to second homes etc... The genius arrived and so far so good. As you can see in my pics, I've had a few successes, but when it came to the gears they just won't move. The bed was levelish, and it seemed the filament was too much for the print to take, at least at first. The top is quite good. Any ideas?
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • James Burn uploaded 3 photos in the album My genius pics
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • As mentioned above, the links do not show up in Chrome, but do in Safari.

    1. View Post →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • James Burn just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.