Slider
Introduction
Pinned Items
Recent Activities
  •   Earl Miller commented on this post about 1 week ago
    Hi, I use the Artillery SWX1 Marlin 1.1.9 Advanced Firmware and GUI for about 2 months without problem. But this morning, when I light on my x1, all seems normal but I press icons of 1st level with no effect. I tried to reflash the tft firmware but the machine seems not detecting the micro-sd (I tried differents firwmares and different sd-cards). WIth octoprint, I can control the machine and print. Do you have an idea of what I can do ?
    0
    0
    0
    0
    0
    0
    • If the LCD is unresponsive it may be bad, or, it might be grounding out. People have used nail polish on the board corners where they screw into theIf the LCD is unresponsive it may be bad, or, it might be grounding out. People have used nail polish on the board corners where they screw into the case so they dont short out. I use rubber washers between the boards and the case instead.  More ...
      0
      0
      0
      0
      0
      0
      Reported
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Stream item published successfully. Item will now be visible on your stream.
  • Jean Philippe updated his profile picture
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Jean Philippe just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.