Slider
Introduction
Pinned Items
Recent Activities
  • Hi all, I'm looking to put a all metal hotend in my genius but am having trouble finding the right one. Its the non threaded version and I'm just not sure what fits it. I got the e3d threaded one figuring it'd be right but no, so wasted money already and don't want to do it again.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  •   joel hull commented on this post about 2 months ago
    Hi all, I'm having troubles with my genius. No matter what i do it seems to be trying to print too high. I've tried leveling the bed between .1 to .04mm and its still too high. It'll print purge lines up the side fine but as soon as the print starts (no matter where on the bed) its high.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  •   joel hull commented on this post about 4 months ago
    Hi all, I've recently started having strange problems with my genius. There's a clicking when retracting and prints have become stringy. Had the whole head apart and found a loose screw but it doesn't seem to have fixed the problem. I've played around with retract settings, messed with filament tensions and everything else i could think of and nothing has helped.

    Im sort of new to this and am out of ideas what it could be.

    Any ideas would be much appreciated.
    0
    0
    0
    0
    0
    0
    • Clicking is usually too high retract and possibly filament tension. As for strings, Retract, coast and wipe settings. Try one of our profiles andClicking is usually too high retract and possibly filament tension. As for strings, Retract, coast and wipe settings. Try one of our profiles and start from there.  More ...
      0
      0
      0
      0
      0
      0
      Reported
    • Thanks Earl. Also, thanks for the efforts put into the profiles and firmware. MBL is a lifesaver, my bed drops in the centre. Already using yourThanks Earl. Also, thanks for the efforts put into the profiles and firmware. MBL is a lifesaver, my bed drops in the centre. Already using your profiles as a base point, have from the start. Pulled the retact back .5 and 5mm/s and its all good. Am testing coasting out now.


      While im asking questions. Messing around yesterday i printed these cubes and got these identical weird layers from two different g codes. Any ideas?
        More ...
      0
      0
      0
      0
      0
      0
      Reported
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Love the MBL but is there and way i can set it up to be a 5x5 grid instead of the 3x3?

    1. View Post →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • joel hull just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.

3D-Nexus is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com at no additional cost to you.