Slider
Introduction
Pinned Items
Recent Activities
  •   Bob Bryce commented on this post about 1 month ago
    Upgraded to Cura 4.7. Installed the config package, but I only have a .4 nozzle listed in the nozzles drop down. Please advise... Thank you
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Anyone upgrade to Cura 4.7? I am only getting the .4 nozzle option listed in the nozzles drop down.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  •   Earl Miller commented on this post about 5 months ago
    I loaded Cura 4.6.1 and then the profiles for the X1, but the nozzles don't show up in the nozzles list. Please advise.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Robert Blot reacted to an article, Artillery 3D Printers
     
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • In simplify3d I can setup a profile for each layer of a 5 part stack. I did this so I could slow down the first layer of each part in the stack. Can I do this in Cura 4.6?
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • What is the best method for changing acceleration and jerk settings when eeprom is active and Marlin 1.1.9 advanced is loaded?
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Robert Blot just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.

3D-Nexus is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com at no additional cost to you.