Slider
Introduction
Pinned Items
Recent Activities
  •   Earl Miller commented on this post about 5 months ago
    Hey everyone!! What are the thoughts on the tension belt for the Z axis rails? Could I take it off and use wither Waggester or 3D Nexus FW with no problems? I realized my X carriage is not parallel to the printer and even with the BLTouch one side is always higher than the other. I appreciate the input and help!!
    0
    0
    0
    0
    0
    0
    • You could take it off and some people have, but its there for a reason. If your X axis is not parallel, you need to address that- resetting the rodsYou could take it off and some people have, but its there for a reason. If your X axis is not parallel, you need to address that- resetting the rods and couplers with a pair of spacers (can be anything, Ive seen people use soda cans but I preferred making some from a 3D print or blocks of wood), then reassembling and tightening the gears and belt on the top.
        More ...
      0
      0
      0
      0
      0
      0
      Reported
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Gilbert Patrucco just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.

3D-Nexus is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com at no additional cost to you.