Slider
  •   Earl Miller commented on this post about 7 months ago
    Hey everyone!! What are the thoughts on the tension belt for the Z axis rails? Could I take it off and use wither Waggester or 3D Nexus FW with no problems? I realized my X carriage is not parallel to the printer and even with the BLTouch one side is always higher than the other. I appreciate the input and help!!
    0
    0
    0
    0
    0
    0
    • You could take it off and some people have, but its there for a reason. If your X axis is not parallel, you need to address that- resetting the rodsYou could take it off and some people have, but its there for a reason. If your X axis is not parallel, you need to address that- resetting the rods and couplers with a pair of spacers (can be anything, Ive seen people use soda cans but I preferred making some from a 3D print or blocks of wood), then reassembling and tightening the gears and belt on the top.
        More ...
      0
      0
      0
      0
      0
      0
      Reported
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
Copyright © 2017-2020 Earl Miller. All Rights Reserved. No part of this site may be reproduced without express consent by the owners for their respective content. 3D-Nexus is a creative IP (intellectual property) soley owned by Earl Miller.

3D-Nexus is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com at no additional cost to you.